Ethylene oxide sterilizer manufacturer

EO sterilizer.Made In China

Sterilizer instructions
Contact us

Mail: sterilizerfactory@gmail.com

Contacts: Jacky Jiang

TEL: 0086 18258800889

FAX: 0086 371 55951125

ADD: Liangzhu Economic Development Zone, Hangzhou.

  • Which sterilizer cabinet is better
  • What sterilization method is used for surgical mask
  • How to disinfect surgical mask
  • Safety inspection of ethylene oxide sterilizer
  • How do you decontaminate a gas mask
  • Sterilizer instructions

    Installation of sterilizer

    by:EtO sterilizer Manufactorview: 1303 time: 2020-03-05

    Installation of sterilizer

    Installation of sterilizer

    The sterilizer should be placed in a special room. The room shall be connected with power (steam source), water source, drainage and ventilation facilities, and equipped with special grounding device.
    Installation position of sterilizer. There should be a certain space around for installation and maintenance; there should be enough space in front of the sterilizer door to ensure convenient access of sterilized articles. Sterilizer should be placed as horizontal as possible.
    The power supply shall be connected to three-phase four wire AC 380V-50Hz power supply and equipped with special distribution board. The setting out trench shall be opened between the sterilizer box and the electrical control cabinet.
    The steam source of water source is connected with pressure gauge and corresponding manual valve to ensure the use safety. The diameter of the sewer pipe shall not be less than 100 mm.
    The gas cylinder shall be connected with a pressure gauge. It is not known that it is close to the heat source or exposed to the sun. The storage temperature shall be less than 50 ℃.

    Precautions

    • 1. Ethylene oxide is inflammable and explosive, so it is very important to ensure safety. Therefore, the sterilization workshop should be equipped with fire prevention measures. In addition, no smoking, no other open fire, and keep the workshop ventilated.
    • 2. Ethylene oxide is toxic to some extent. If the human body inhales too much at one time, it will have discomfort, even headache, vomiting and other toxic phenomena. In case of the above phenomenon, leave the site quickly and breathe fresh air in the open and cool place until the symptom is eliminated. For example, the human skin and eyes are exposed to ethylene oxide
    • 3. The water in the water circulation system shall be replaced regularly. Replace the waste water in the waste gas treatment system regularly.


    Applicable scope of gas sterilization

    Ethylene oxide does not damage the sterilized articles and has strong penetration, so most articles that are not suitable for general sterilization can be sterilized and sterilized with ethylene oxide. For example, electronic instruments, optical instruments, medical devices, books, documents, fur, cotton, chemical fiber, plastic products, wood products, ceramics and metal products, endoscopes, dialyzers and disposable medical supplies. Ethylene oxide is one of the most important low temperature sterilization methods.

    Advantage

    Convenient transportation and storage, no need of huge gas cylinder, no need of filtering gas, more importantly, CFC free. Environmental protection and safety.

    Summary

    At present, ethylene oxide is widely used to sterilize medical devices. . ethylene oxide is a flammable and explosive toxic gas, with the molecular formula of C2H4O, which has an aromatic ether smell. At 4 ° C, the relative density is 0.884, the boiling point is 10.8 ° C, and the density is 1.52g/cm3. At room temperature, it is easy to volatilize into a gas, which can cause explosion when the concentration is too high.
    Classification:Sterilizer instructions
    Recommended
    Recommended products
    Online Service
    0086 18258800889

    0086 371 55951125

    EO sterilizer
    OnlineService